Inground Pool Closing Steps

How do I add chemicals to the pool l Zodiac Australia Water Chemistry
Outdoor Leisure Inground Pool Steps by Only AlphaOutdoor Leisure Inground Pool Steps by Only Alpha

Preparing for Winter: Steps to Close Your Inground Pool

Introduction

As the summer season comes to an end, it’s time to start thinking about closing your inground pool for the winter. Properly closing your pool is crucial to ensure it stays in good condition during the colder months and is ready for use when spring arrives. In this article, we will guide you through the essential steps to close your inground pool effectively.

Step 1: Clean and Balance the Water

The first step in closing your inground pool is to clean it thoroughly. Remove any debris, leaves, or dirt from the water using a pool net or skimmer. Next, test the water and ensure it is properly balanced. The pH levels should be between 7.4 and 7.6, and the alkalinity should be around 100-150 ppm. Adjust the chemicals as necessary to achieve the optimal balance.

Step 2: Lower the Water Level

To prevent freezing and potential damage to your pool, it’s essential to lower the water level. Drain the water until it reaches a level just below the skimmer. You can use a submersible pump or a hose to drain the excess water. Remember to turn off the electricity supply to the pump before starting this process.

Step 3: Winterize the Plumbing System

Freezing temperatures can cause the water in your pool’s plumbing system to expand, leading to cracks and costly repairs. To avoid this, you need to winterize the plumbing system. Start by removing any detachable equipment, such as ladders or diving boards. Then, blow out the plumbing lines using an air compressor to remove any water. Finally, plug the lines to prevent any water from re-entering.

READ:  Above Ground Pool Interior Steps

Step 4: Protect Your Pool Equipment

Properly storing and protecting your pool equipment is crucial to ensure its longevity. Remove and clean any filters, pumps, or heaters. Store them in a dry place, preferably indoors, to prevent damage from the winter weather. Additionally, cover your pool’s skimmer and return lines with winterizing plugs to protect them from freezing temperatures.

Step 5: Cover Your Pool

The final step in closing your inground pool is to cover it with a winter pool cover. Ensure that the cover is securely fastened and completely covers the pool, preventing any debris or leaves from entering. For added protection, consider using a pool cover pump to remove any rainwater or snow that accumulates on top of the cover.

Conclusion

By following these steps, you can effectively close your inground pool for the winter season. Properly cleaning, balancing the water, and winterizing the plumbing system will help prevent damage and ensure a hassle-free opening when spring arrives. Remember to store and protect your pool equipment and cover your pool with a winter pool cover to keep it in optimal condition. By taking these precautions, you can enjoy a beautiful and well-maintained pool for years to come.

Leave a Reply

Your email address will not be published. Required fields are marked *

close